Disassembly And Reassembly - Samsung SCX-1100 Service Manual

3. Disassembly and Reassembly

3-1 General Precautions on Disassembly
When you disassemble and reassemble components, you
must use extreme caution.
The close proximity of cables to moving parts makes proper
routing a must. If components are removed or replaced, any
cables disturbed by the procedure must be replaced as close
as possible to their original positions.
Before removing any component from the machine, note the
cable routing that will be affected.
3-2 Scanner Ass'y
1. Remove two screws securing the rear cover.
2. Open the front door from the main cover.
samsung Electronics
Whenever servicing the machine, you must perform as fol-
lows:
1. Check to verify that documents are not stored in memory.
2. Unplug the power cord.
3. Use a flat and clean surface.
4. Replace only with authorized components.
5. Do not force to remove or planten plastic-material compo-
nents.
6. Make sure all components are in their proper position.
3. Remove two screws securing the main cover.
4. Pull the scanner ass'y upward then, unplug the two
connectors and CCD cable.
Note : You should connect or remove the CCD cable verti-
cally to avoid the CCD cable pin damage.
3-1