Table of Contents
Advertisement
Disconnect and reconnect power to the switcher.
All front panel LEDs blink four times, then
turn off. The Video and Audio LEDs light red.
Press and hold the I/O button and continue to
hold it until only the I/O Video LED is lit green.
Release the I/O button.
Figure 26.
3.
When only the Video LED is lit steadily green, release the
Resetting Using the Rear Panel Reset Button
The rear panel has a recessed
various levels of soft resets, which restore various tiers of switcher settings to their defaults.
For different reset levels, press and hold the button while the switcher is running or press
and hold the button while you apply power to the switcher. Use a pointed stylus, ballpoint
pen, or small screwdriver to press the button.
The
table
ATTENTION:
•
Review the reset modes in the
reset mode could result in unintended loss of flash memory programming, port
reassignment, or a switcher reboot.
•
Analysez minutieusement les différents modes de réinitialisation voir
suivante. Appliquer le mauvais mode de réinitialisation peut causer une perte
inattendue de la programmation de la mémoire flash, une reconfiguration des ports
ou une réinitialisation du sélecteur.
NOTES:
•
The reset modes listed in the table close all open IP and Telnet connections and all
sockets.
•
The modes described in the table are separate functions, not a continuation from
mode 1 to mode 5.
•
There is no reset mode 2 for DXP HD 4K PLUS.
•
Because DXP HD 4K PLUS switchers do not support events, reset mode 3 is also
unavailable. If you attempt to initiate it, the Reset LED blinks 3 times but no reset is
performed.
Power
System Reset, DXP 88 Series
Reset
on the next page provides a summary of the reset modes.
VIDEO
I/O
AUDIO
VIDEO
I/O
AUDIO
I/O
button (see
figure 2,
, on page 6) that initiates
D
table on the next page
carefully. Using the wrong
DXP HD 4K PLUS Series • Operation
button.
tableau page
28
Advertisement
Table of Contents
