Table of Contents
Advertisement
Connection
6.2 Electrical connection
6.2.4
Rotating the connectors
Power connector, signal connector, and DRIVE-CLiQ can, to some extent, be rotated. A
suitable socket connector can be used to rotate the angle plug. Make sure that the socket
connector is completely secure to avoid damaging the pin contacts.
NOTICE
It is not permissible to exceed the specified rotation range.
In order to guarantee the degree of protection, max. 10 revolutions are permissible.
Connectors should be rotated using the matching mating connector located on the
Figure 6-4
Ability to rotate the connectors (P = power connector, S = signal connector)
Table 6- 3
Connector
Power connector, size 1
Power connector, size 1.5
Signal connector
DRIVE-CLiQ (connector)
The size 3 power connector cannot be rotated.
NOTICE
Cable outlet direction
If the direction of the cable outlet is not changed correctly, this can damage the connecting
cables. The direction of the cable outlet must not be changed since this renders all warranty
claims invalid.
34
connector thread. Only rotate the Sensor Module by hand. The use of pipe wrenches,
hammers, or similar is not permitted.
Maximum rotating torques that occur
M
max
12 Nm
20 Nm
12 Nm
8 Nm
1FT7 synchronous motors
Operating Instructions, 04/2010, 610.40075.40b
Advertisement
Table of Contents
