Replacing The Back Cover - Cisco AIR-MP20B User Manual

9. Carefully position the antenna wires so that the metal connectors do not
touch each other.
10. Verify the following:
a. The card is properly secured with both retaining clips engaged.
b. The antenna board is properly secured.
c. The antenna connectors are not touching.
Caution Do not allow the antenna connectors to touch while power is
applied. If they are touching, carefully rotate them in opposite
directions until they are separated.

Replacing the Back Cover

Follow these steps to replace the back cover:
1. While holding the back cover near the connector end of the access point,
carefully place the latches on the antenna end into the detents on the end
of the front cover.
2. Release the back cover and with one finger gently push the connector
end of the back cover towards the antenna end. The back cover drops into
place and slides forward until it is fully seated.
13