Opening The Access Point Hinged Cover - Cisco Aironet 1520 Series Hardware Installation Manual

Mounting the Access Point
Step 7 Continue with the
Point" section on page

Opening the Access Point Hinged Cover

You need to open the access point hinged cover when you are performing these operations:
•
•
To open the access point hinged cover, follow these steps:
Step 1 Use 0.5-in. (13-mm) box-end wrench or socket set to unscrew the six bolts on the front cover of the unit.
Only unscrew the bolts about 2 turns until they are easily turned by hand, do not remove the bolts.
Step 2 The cover is hinged on the bottom. Carefully open the cover and swing it down.
Note
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
2-38
"Grounding the Access Point" section on page 2-42
2-46.
Installing a cable POC Stinger connector
Installing fiber-optic SFP module and fiber cable take-up reels
If the cover does not swing open easily, carefully loosen the hinge bolts again.
Chapter 2 Mounting Instructions
and the "Powering the Access
OL-12632-02