Removing The Blank Spacer Card - Cisco AIR-MP20B User Manual

Removing the Blank Spacer Card

When your access point is not configured with a 2.4-GHz radio, it contains a
blank spacer card in the internal mini-PCI connector. You must remove the
blank spacer card prior to installing your 802.11g radio. If you are replacing
an existing 2.4-GHz radio, go to the
page 20.
Caution Handle all components carefully and observe all ESD
precautions. The internal access point components can be
damaged by ESD if not handled properly.
Follow these steps to remove the blank spacer card from the mini-PCI
connector. It may be helpful to refer to the following illustration before you
proceed.
"Removing a 2.4-GHz Radio" section on
17