Replacing The Back Cover - Cisco AIR-AP1121G-E-K9 Hardware Installation Manual

Chapter 7 2.4-GHz Radio Upgrade
Step 7 Insert the antenna card into the notch in the support bracket and gently push until it is seated (see
Figure
Figure 7-5
1
2
Step 8 Align the hole on the top of the antenna board with the support post and gently push down until the board
is fully seated on the support post (see
Step 9 Verify the following:
The radio car is properly secured with both retaining clips engaged.
a.
The antenna board is properly seated.
b.
The antenna connectors are not touching.
c.
Do not allow antenna connectors to touch while power is applied, or the radio can be damaged. If they
Caution
are touching, carefully rotate them in opposite directions until they are separated.
Go to the
OL-4309-02
7-5).
Inserting Antenna Card
2
1
Antenna card
Support post hole
"Replacing the Back Cover" section on page
3
3 Support bracket notch
Figure 7-5).
7-8.
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
Installing a 2.4-GHz Radio
7-7