Installing The 802.11G Radio Card - Cisco AIR-MP20B User Manual

3. Place the card in an anti-static bag.

Installing the 802.11g Radio Card

Follow these steps to install the 802.11g radio card:
1. Carefully remove the radio card from its anti-static bag.
2. Grasp the card by its edges, being careful not to touch components on
the card or the gold connector pins.
3. Carefully connect the black wire's antenna connector to the radio card
antenna connector marked J2 (the connector on the outside of the card).
4. Carefully connect the white wire's antenna connector to the radio card
antenna connector marked J1 (the connector on the inside of the card)
connector).
5. Insert the radio card into the access point's mini-PCI connector by
following these steps:
a. Tilt the card at approximately 20 to 30 degrees so that its gold pins
are aligned with the mini-PCI connector.
b. Insert the card into the mini-PCI connector and gently push the card
until it is firmly seated as shown in the following illustration.
22