Printing - FujiFilm Instax SQUARE SQ10 User Manual

Printing

Print an image following the steps below.
EN
• When the auto print mode is selected, the image will be
printed immediately after it is taken. (Page 13)
~
Press the (Playback) button.
The most recent image will be displayed.
Ÿ
8 9
Press or to select an image to view.
8
Pressing displays a previous image.
9
Pressing displays a next image.
!
Adjust the image effect as necessary.
(Pages 17 and 18)
⁄
Press the (Print) button.
The screen below appears.
16
instax_D-SQ_6lang.indb 16 instax_D-SQ_6lang.indb 16
@
Press the MENU/OK button.
Printing starts.
• To cancel printing press the
¤
When the film has been
ejected (the camera stops
making a sound), grab the
edges of the film, then take
it out.
■ Film remaining indication
Dots on the right of the monitor indicates the number
of remaining films.
One dot turns gray every time you print an image.
• When there are only two films left, dots turns
red.
R You can print an image that is zoomed in or print four
or nine images on one film. Use the command dial to
change to the multiple image display on step 2 when
the image to print is displayed. (Page 15)
• For details on taking out the film, refer to the instructions and
warnings on the FUJIFILM Instant Film "instax SQUARE" pack.
• The development time is approximately 90 seconds. (The
time varies depending on the ambient temperature.)
(Back) button.
2017/2/20 14:12:08 2017/2/20 14:12:08