Fujifilm INSTAX SQUARE SQ1 Instant Camera Manual

Fujifilm INSTAX SQUARE SQ1 Instant Camera Manual

Also See for instax SQUARE SQ1:

Advertisement

Fujifilm INSTAX SQUARE SQ1 Instant Camera Manual

Operations

Operations - Part 1
Operations - Part 2
Operations - Part 3
Operations - Part 4

Names of Parts

Names of Parts

  1. Flash lampface
  2. Film ejection slot
  3. Flash charging lamp
  4. Viewfinder
  5. Shutter button
  6. Lens ring / Power
  7. AE light sensor
  8. Flash light sensor
  9. Lens barrel
  10. Selfie mirror
  11. Lens cover / Lens
  12. Strap eyelet
  13. Back cover lock
  14. Film confirmation window
  15. Back cover
  16. Film counter
  17. Battery lid
  18. Viewfinder eyepiece

Taking Pictures

Do not open the back cover until you have used up the film. Otherwise, the rest of the film will become exposed and turn white, and can no longer be used.

  1. Turn on the camera by rotating the lens ring to ON.
    The lens barrel extends and the flash charging lamp blinks and then lights up. (Blinking indicates that the flash is charging.)
    Taking Pictures - Turning the camera on
  2. Hold the camera, look through the viewfinder of the camera to frame your desired composition, and press the shutter button.
    * The shutter button cannot be pressed while the flash is charging.
  3. When the sound of the film being ejected stops, grasp the edge of the ejected film and take the film out.

    The film counter decreases in numerical order, counting down from "10" with each photo taken. "0" will be displayed when the film is finished and after the last photo has been taken.
  4. When you have finished taking photos, turn off the camera by rotating the lens ring to OFF.

If the camera malfunctions, remove the batteries while the power is on and then reinsert them to reset the camera.

Taking a Photo in Selfie Mode

Taking a picture of yourself

If you shoot in selfie mode, you can take a picture of yourself using the selfie mirror on the front of the camera to confirm your exposure.

  1. Rotate the lens ring to SELFIE and pull out the lens to the selfie mode.
  2. Hold the camera securely with both hands so that your face is 30 to 50 cm away from the end of the lens.
  3. Confirm the composition using the selfie mirror, then push the shutter to take the photo.

Taking a closeup

If you shoot in selfie mode, you can move the camera close to the subject and take a closeup.

  1. Rotate the lens ring to SELFIE and pull out the lens to the selfie mode.
  2. Hold the camera so that the mark in the viewfinder sits slightly to the upper right of the center of the subject, then press the shutter button to take a photo.

Precautions for Taking Photos

Precautions for Holding the Camera

Precautions for Holding the Camera

  • Take care that a finger or the strap does not cover the flash light sensor, AE light sensor, flash lampface, lens, or film ejection slot.
  • Hold the camera so that the flash lampface is at the top when taking a horizontal picture.
  • Do not take pictures in locations where flash photography is forbidden.
  • Do not grasp the lens barrel when holding the camera. The finished photos may be adversely affected.
  • Look into the viewfinder so that the viewfinder appears in the center.
  • Be careful not to touch the lens when you press the shutter button.

Distances for Normal Mode and Selfie Mode

  • In normal mode, take a picture at a distance of at least 0.5 m from the subject. The effective flash range is up to approximately 2.7 m.
  • When holding the camera closer than 0.5 m from the subject, use the selfie mode. Use the selfie mode to capture a closeup within the range of 30 to 50 cm.

Flash charging lamp states and error solutions

Flash charging lamp state Description
Lit Ready to take a photo.
Off Camera is off.
Flashing slowly Charging the flash. Please wait until the flash charging lamp lights.
Charging normally takes 3 to 10 seconds to complete.
Flashing quickly An error has occurred.
Main errors Cause and solution
Battery check failed The flash cannot be charged because the battery voltage is insufficient. Replace the batteries with new ones.
Film jammed Do not forcibly pull out the film. Removing and reinserting the batteries while the power is on may enable the film to be ejected.

Safety Precautions

  • Do not use this product and its accessories for a purpose other than taking photos.
  • This product has been designed with safety in mind, but please read the following safety precautions carefully and then use the product correctly.
  • After reading this User's Guide, be sure to keep it in an easy-to-access place where you can refer to it whenever necessary.

burn hazardburn hazard
This indicates a matter that may lead to death or serious injury if ignored or incorrectly handled.

shock hazard Do not disassemble this product. Electric shock may occur.
shock hazard Do not touch this product if the inside of it becomes exposed due to dropping, etc. This product has highvoltage circuitry that may cause electric shock.
burn hazard If you notice anything abnormal, such as the camera (batteries) becoming hot, emitting smoke, or making a burning smell, remove the batteries immediately. Fire or burns may occur (be careful not to burn yourself when removing the batteries).
warning Never take flash photographs of people riding bicycles, driving cars, skateboarding, riding a horse and the like. The flash can be startling, distract, frighten animals, and otherwise cause an accident.
burn hazard If you drop the camera in water or if water or a piece of metal or other foreign object gets inside, remove the batteries immediately. Heat generation or fire may occur.
warningburn hazard
Do not use this camera in places where there is flammable gas or near open gasoline, benzine, paint thinner or other unstable substances which can give off dangerous vapors. Failure to do this could result in explosion or fire.
warning Keep the product out of the reach of infants and small children. Injury may occur.
danger Do not disassemble, heat the batteries, throw them in a fire, or put them in an electrical short circuit. The batteries may rupture.
burn hazard Use only CR2 batteries. Heat generation or fire may occur if other batteries are used.
warning Keep batteries out of the reach of infants. An infant may accidentally swallow a battery. In the event that a battery is swallowed, seek medical attention immediately.


This indicates a matter that may lead to injury or physical damage if ignored or incorrectly handled.

warning shock hazard
Do not get this product wet or handle it with wet hands. Electric shock may occur.
warning Using a flash too close to a person's eyes may for the short term affect their eyesight.
warning Take care when taking pictures of infants and young children. Take care not to make a mistake with the and polarities when inserting the CR2 batteries. Damages to the surroundings may occur due to the camera being damaged or its battery fluid leaking out.
warning Do not touch moving parts inside the camera. You may be injured.

Handling

Handling of Camera

  1. The camera is a precision instrument, so do not get it wet, drop it, or subject it to shock. Also, do not place the camera where it will be exposed to sand.
  2. Before using a commercially available strap, check the strength of the strap. Be especially careful when using a strap for mobile phones and smartphones because such straps are made for lightweight devices.
  3. If you are not using your camera for a long interval, unload the batteries and keep it where it will avoid heat, dust and moisture.
  4. Remove soil and dust from the viewfinder window, etc. with an air blower and by wiping gently with a piece of soft cloth.
  5. Do not use solvent such as thinner or alcohol to wipe off dirt.
  6. Do not leave the camera in a closed motor vehicle, another hot place, a humid place, on the beach, etc. for any period of time.
  7. Moth repellent gas such as naphthalene will adversely affect the camera and film. Avoid keeping the camera and film in a chest of drawers, etc. with mothballs.
  8. The operating temperature range of this camera is +5°C to +40°C.
  9. This camera may occasionally malfunction because it is controlled by a micro computer. If it malfunctions, remove and then reinsert the batteries to reset the camera.

Handling of Film and Photos

For details on the handling of film and photos, see the instructions of FUJIFILM instax SQUARE instant film.

  1. Keep film a cool place. In particular, do not leave film in an extremely hot place, such as in a closed motor vehicle, for a long period of time.
  2. Use film as soon as possible after inserting it in the camera.
  3. If film has been kept in a place where the temperature is extremely low or high, allow it to become accustomed to a normal temperature before taking pictures.
  4. Use film before the film expiration date referenced on the package.
  5. Avoid airport checked luggage inspection and other strong X-ray exposure. Unused film is susceptible to the effect of fogging, etc. We recommend that you carry film onto aircraft in carry-on luggage (check with the relevant airport for more information).
  6. Avoid exposing photos to strong light, and store them in a cool and dry place.
  7. Do not make a hole in film or tear or cut film. Do not use film that is damaged.
  8. Do not cut or disassemble the film for this camera as it contains black caustic alkali paste. Be especially careful not to let infants or pets put the film into their mouths. Also take care that the paste does not come into contact with skin and clothes.
  9. If you accidentally touch the paste of unused film, immediately wash it off with plenty of water. If the paste comes into contact with the eyes or mouth, wash the area and then seek medical attention. The alkalinity of this film will weaken approximately 10 minutes after the photo is ejected from the camera.

Cautions on Handing of Film and Finished Photos

For details, see the instructions of FUJIFILM instax SQUARE instant film.
Cautions on Handing of Film and Finished Photos


The "CE" mark certifies that this product satisfies the requirements of the European Union (EU) regarding safety, public health, environment, and consumer protection. ("CE" is the abbreviation of Conformité Européenne.)

  • Legally required regulation compliance displays are located on the inside of the back cover of the camera.


Disposal of Electric and Electronic Equipment in Private Households
Disposal of used Electrical & Electronic Equipment
(Applicable in the European Union and other European countries with separate collection systems)

For customers in Turkey:
EEE Complies with Directive.

Specifications

Film FUJIFILM instax SQUARE instant film
Photo Picture Size 62 mm × 62 mm
Lens 2 components, 2 elements, f = 65.75 mm, 1:12.6
Viewfinder Reverse Galilean finder, 0.4×, with target spot
Shooting Range 0.3 m and beyond (use selfie mode for 0.3 m to 0.5 m)
Shutter Programmed electronic shutter 1/2 to 1/400 sec.
Slow synchro for low light
Exposure Control Automatic, Lv 5.0 to 15.5 (ISO 800)
Film Ejection Automatic
Film Developing Time Approx. 90 seconds (varies depending on the ambient temperature)
Flash Constant firing flash (automatic light adjustment), recycle time: 7.5 seconds or less (when using new batteries), effective flash range: 0.3 to 2.2 m
Power Supply Two lithium batteries (CR2), capacity: approx. 30 instax SQUARE film packs (under FUJIFILM test conditions)
Auto Power Off Time After 5 minutes
Other Includes film counter and film pack confirmation window
Dimensions 130.7 mm × 118.6 mm × 57.5 mm
Weight 390 g (without batteries, strap, and film)

Information for traceability in Europe
Manufacturer: FUJIFILM Corporation
Address, City: 7-3, Akasaka 9-Chome, Minato-ku, Tokyo
Country: JAPAN
Authorized representative in Europe:
FUJIFILM EUROPE GMBH
Address, City: Dusseldorf Heesenstrasse 31, 40549
Country: Germany

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Fujifilm INSTAX SQUARE SQ1 Instant Camera Manual

Advertisement

Need Assistance?

Do you have a question about the instax SQUARE SQ1 that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents