Repeating Graphic Simulation; Tool Display - HEIDENHAIN TNC 620 User Manual

Graphics (Advanced Graphic Features software option) 16.1

Repeating graphic simulation

A part program can be graphically simulated as often as desired. To
do so you can reset the graphic to the workpiece blank.
Function
Show the unmachined workpiece blank

Tool display

Regardless of the operating mode, you can also show the tool
during the simulation.
Function
Program Run, Full Sequence / Program Run, Single
Block
Test Run
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
Soft key
Soft key
16
509