Assembly - Reebok 1000 ZX RBEL9906.3 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own Phillips screwdriver
mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: Some small parts may have
been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M6 Split Washer M8 Split
(102)–8
Washer (101)–4
M4 x 16mm
Screw (116)–16
Wave Washer
(100)–2
M8 x 15mm Button
Screw (106)–10
1. If there is a shipping bracket attached to the
rear of the Folding Frame (not shown), remove
the screw and the shipping bracket from the
Folding Frame. Discard the screw and the ship-
ping bracket.
See HOW TO FOLD AND UNFOLD THE
ELLIPTICAL EXERCISER on page 11 and
unfold the elliptical exerciser.
While another person lifts the front of the
Frame (1), attach the Front Stabilizer (4) to the
Frame with two M10 x 93mm Button Screws
(82) and two M10 Curved Washers (99).
M8.5 x 16mm x
1.5mm Washer
(103)–6
M6 x 35mm
Screw (109)–4
M8 x 20mm Button
Screw (107)–4
M10 x 93mm Button Screw (82)–4
M10 x 25mm M10 Curved
Washer (87)–2
Washer (99)–4
M8 x 25mm Button
Screw (110)–2
1
82
99
99
4
5
and rubber
Link Arm
Spacer (74)–4
M6 x 62mm
Screw (108)–4
M10 x 20mm Button
Screw (111)–2
1