Removing The Slip Detection; Photosensors - Olivetti PR4 SLIP Service Manual

5.10 REMOVING THE SLIP DETECTION

PHOTOSENSORS

• Remove the case (Section 5.2).
• Remove the print assembly (Section 5.4).
• Remove the paper guide plate in order to be able to
access the photosensor assembly.
PROCEED VERY CAREFULLY.
SLIP DETECTION
PHOTOSENSORS
XYAA6338
• Remove the assembly by unscrewing the securing
screw shown in the figure.
Note: The photosensor assembly must be adjusted
with respect to the platen as explained in the
section Adjusting the Photosensors
(Section 6.6.1).
SECURING SCREW
PR4
Fig. 5-12
Service Manual
PLATE
5-13