Removing Snowplow From Vehicle & Storage - Blizzard POWER PLOW 8100PP Owner's Manual

REMOVING SNOWPLOW FROM VEHICLE & STORAGE
REMOVING SNOWPLOW (OFF)
WARNING
Keep 8' clear of the blade when blade is being
raised, lowered, or angled. Do not stand
between the vehicle and blade or directly in
front of blade. If the blade hits or drops on
you, you could be seriously injured.
WARNING
Inspect snowplow components and fasteners
for wear or damage whenever mounting or
removing the snowplow. Worn or damaged
components could allow the snowplow to
drop unexpectedly.
During the off -season, the control can be removed.
Disconnect the connector in the cab and store the
control in the glove box of the vehicle.
1. Lower snowplow onto ground with blade straight.
Turn control in cab OFF.
2. Move power switch to center, or "OFF," position.
Arm / Blade
Power
Operation
Switch
Switch
Switch
Label
3. While holding the power switch RIGHT, push
DOWN and hold the Arm/Blade Operation switch.
Arm will disengage mount adapter to relieve
tension on the stand.
Lit. No. 40691, Rev. 05
4. Pull the stand pin out. Rotate the stand down until
the stand pin seats into the lower A-frame hole.
The stand pin must lock into the lower A-frame
hole. Push down on the top of the shoe. The shoe
will be on the ground.
Blade
5. Repeat Step 4 on the passenger's side.
6. Push and hold power switch RIGHT and push
UP the Arm/Blade Operation switch. Arm will
engage mount adapter and pull snowplow tightly
to vehicle.
Light
Tower
7. Rotate and pull the hitch pin. Rotate the hitch pin
into the retracted position.
8. Repeat Step 7 on the passenger's side.
28
Light Tower
Boot
Power Switch
Raise
OFF
Lower
POWER ARM/BLADE
48207 OPERATION
Upper Hole
Stand
Stand Handle
OFF
Pin
Guide Plate
Hitch
Pin
Arm/Blade
Operation Switch
Mount
Hitch Pin
Adapter
A-Frame
Arm
Stand Pin
Shoe
Mount
Adapter
Pin
Handle
May 1, 2021