Suppression Ferrites; Connections To Other Equipment; Declaration Of Conformity; Product Disposal - Raymarine C90W Installation Manual

Note: Where constraints on the installation prevent any of
the above recommendations, always ensure the maximum
possible separation between different items of electrical
equipment, to provide the best conditions for EMC performance
throughout the installation

Suppression ferrites

Do not remove ferrite
Raymarine cables may be fitted with suppression ferrites. These
are important for correct EMC performance. If a ferrite has to be
removed for any purpose (e.g. installation or maintenance), it must
be replaced in the original position before the product is used.
Use only ferrites of the correct type, supplied by Raymarine
authorized dealers.

Connections to other equipment

Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment
using a cable not supplied by Raymarine, a suppression ferrite
MUST always be attached to the cable near the Raymarine unit.

Declaration of conformity

Raymarine Ltd. declares that the C-Series Multifunction Displays
are in compliance with the essential requirements of EMC directive
2004/108/EC.
10
The original Declaration of Conformity certificate may be viewed on
the relevant product page at

Product disposal

Dispose this product in accordance with the WEEE Directive.
The Waste Electrical and Electronic Equipment (WEEE)
Directive requires the recycling of waste electrical and electronic
equipment. Whilst the WEEE Directive does not apply to some
Raymarine products, we support its policy and ask you to be aware
of how to dispose of this product.

Warranty registration

To register your C-Series multifunction display ownership, please
take a few minutes to fill out the warranty registration card found in
the box, or visit www.raymarine.com
www.raymarine.com
and register on-line.
C-Series Widescreen installation