Water Ingress; Disclaimer; Suppression Ferrites; Connections To Other Equipment - Raymarine AR200 Installation Instructions Manual

Water ingress

Water ingress disclaimer
Although the waterproof rating capacity of this product meets the stated water ingress protection
standard (refer to the product's
failure may occur if the product is subjected to commercial high-pressure washing. Raymarine will
not warrant products subjected to high-pressure washing.

Disclaimer

Raymarine does not warrant that this product is error-free or that it is compatible with products
manufactured by any person or entity other than Raymarine.
Raymarine is not responsible for damages or injuries caused by your use or inability to use the
product, by the interaction of the product with products manufactured by others, or by errors in
information utilized by the product supplied by third parties.

Suppression ferrites

• Raymarine cables may be pre-fitted or supplied with suppression ferrites. These are important for
correct EMC performance. If ferrites are supplied separately to the cables (i.e. not pre-fitted), you
must fit the supplied ferrites, using the supplied instructions.
• If a ferrite has to be removed for any purpose (e.g. installation or maintenance), it must be replaced
in the original position before the product is used.
• Use only ferrites of the correct type, supplied by Raymarine or its authorized dealers.
• Where an installation requires multiple ferrites to be added to a cable, additional cable clips should
be used to prevent stress on the connectors due to the extra weight of the cable.

Connections to other equipment

Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment using a cable not supplied by
Raymarine, a suppression ferrite MUST always be attached to the cable near the Raymarine unit.

Declaration of conformity

FLIR Belgium BVBA declares that the following products are in compliance with the EMC Directive
2014/30/EU:
• AR200 Augmented Reality Sensor, part number E70537
The original Declaration of Conformity certificate may be viewed on the relevant product page at
www.raymarine.com.

Product disposal

Dispose of this product in accordance with the WEEE Directive.
The Waste Electrical and Electronic Equipment (WEEE) Directive requires the recycling of waste
electrical and electronic equipment which contains materials, components and substances that may
be hazardous and present a risk to human health and the environment when WEEE is not handled
correctly.
Equipment marked with the crossed-out wheeled bin symbol indicates that the equipment
should not be disposed of in unsorted household waste.
Local authorities in many regions have established collection schemes under which residents can
dispose of waste electrical and electronic equipment at a recycling center or other collection point.
10
Technical Specification
), water intrusion and subsequent equipment