ɹ¾·È½» ¾Ëê» ·Äº » »¹Êåè; Operating Tips - Simplicity 1695875 Operator's Manual

¿É¹¾·È½» ¾ËÊ» ·Äº » »¹ÊÅÈ
Manual Chute Rotation
Grasp the chute handle (A, Figure 10) on the deflector
and rotate the discharge chute to the left, right or forward
positiin. A tension plate holds the chute in the desired
position.
NOTE: Do not use the chute handle to lift the unit.
Manual Deflector Adjustment
Loosen the deflector wing knob (B, Figure 10) and adjust
the deflector up or down to control the snow discharge
height and distance. Tighten the wing knob securely to hold
the desired deflector adjustment.
A
Figure 10
en
Discharge Chute
Hand contact with the rotating impeller inside
the discharge chute is the most common
cause of injury associated with snowthrowers.
Never clear or unclog discharge chute with
your hands, or while engine is running.
Fingers can quickly become caught and traumatic amputation
or severe laceration can result.
1. SHUT OFF THE ENGINE!
2. Wait 10 seconds to be sure that the impeller blades
have stopped rotating.
3. Use a clean-out tool to remove snow from the auger
housing.

Operating Tips

1. Most efficient snow removal is accomplished when
snow is removed immediately after it falls.
2. For complete snow removal, slightly overlap each swath
previously taken.
3. Snow should be discharged downwind whenever
possible.
B
4. On gravel or crushed rock surfaces, push down slightly
on the handle bars to avoid ingesting rocks. DO NOT
allow rocks and gravel to be picked up and thrown from
snowthrower.
5. After the snow removal has been completed, allow the
engine to run for a few minutes, to melt accumulated
snow and ice.
6. Clean the snowthrower thoroughly after each use.
7. Before starting snowthrower, always inspect auger for
ice accumulation and/or debris, which could result in
snowthrower damage.
8. Check oil level before every start. Make sure the oil is at
the FULL mark on the oil fill cap/dipstick.
Operation
DANGER
17
17