Section 6; Scheduling Options - Honeywell VISTA-128BPT Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
•
You must program Bypass and Auto-Arm Fail reports for UL installations.
U L
•
Auto-disarming is not permitted in UL installations.
•
You must not program Random Scheduling of Time Driven Events for UL installations.
U LC
Scheduling is not approved for use in ULC installations.
General
The scheduling features allow certain operations to be automated, such as arming, disarming, bypassing of zones, and
activating relay outputs.
The system uses time windows (a programmed period of time with a start and stop time) for defining open/close
schedules, holiday schedules, user-defined temporary schedules, and access schedules for users.
Scheduled events are programmed by user-friendly menu modes of programming (#80, #81, #83, and #93 modes),
explained in detail in this section. These menus take you step by step through the options.
Auto Arming
U LC
Auto Arming is not a ULC Listed feature.
The system can automatically arm (AWAY Mode) a partition at the end of a pre-determined closing (arming) time
window.
Auto Arming can be delayed three ways: by use of the Auto-Arm Delay, the Auto-Arm Warning, or by manually
extending the closing (arming) time window with a keypad command.
The system can also automatically bypass any open zones when auto arming.
Auto-Arm Delay
Auto-Arm Delay provides a delay (grace period) before auto arming. It starts at the end of the closing time window.
The delay is set in 4-minute increments, up to 56 minutes in partition-specific program field 2∗05. At the expiration of
this delay, the Auto-Arm Warning will start.
Auto-Arm Warning
The Auto-Arm Warning causes the keypad sounder to warn the user of an impending Auto-Arm.
The warning can be set from 1 to 15 minutes prior to the arming in partition-specific program field 2∗06. During this
period the keypad beeps every 15 seconds and displays "AUTO ARM ALERT." During the last 60 seconds, the keypads
beep every 5 seconds.
The panel arms at the conclusion of the Auto-Arm Warning period.
Extend Closing Window
A user can manually delay the arm (closing) time window by 1 or 2 hours. This is done by entering a keypad command
(User Code + #82), which then prompts the user to enter the desired extension time of 1 or 2.
This feature is useful if a user must stay on the premises later than usual.
The Auto-Arm delay and warning periods begin at the end of the extension.
Force Arm
U LC
Force Arming is not a ULC Listed feature and must be disabled for ULC installations.
The Force Arm option causes the panel to attempt to bypass any faulted zones prior to auto arming (panel performs a
force-arm).
This option is set in partition-specific program field 2∗08.

Scheduling Options

S E C T I O N 6
6-1