Safety System; To Turn The Burners Off; Power Levels - Bosch PRS926F70E Operating Instructions Manual

Safety system

Thermocouple
Ignition sparker

To turn the burners off

Please note

Power levels

Setting
High
flame
Low
flame
burner is interrupted and the hotplate indicator flashes.
Turn the control knob to 0 and check whether the cause
can be rectified using the table on page 16.
The hob is equipped with an electronic safety system
(thermocouple) that cuts off the gas when the burners are
accidentally switched off. To ensure that this device is
active, switch on the burner as usual.
Every hotplate features a safety pilot!
This means that if the flame ever goes out (e.g. is
extinguished by boiled-over liquid), the flow of gas is
interrupted.
After finishing cooking, turn the controls to position 0 and
disconnect the appliance using the main switch.
The main switch indicator will be turned off.
The appliance switches off automatically after 6 hours of
operation. Turn all the control knobs to the 0 position and
then you can turn the appliance on again.
The progressive control knobs can be used to control the
power needed, from minimum to maximum power.
Control knob
off
Maximum
capacity or
aperture and
electricity
on
Minimum
capacity or
aperture
For dual double-flame burners, the inner and outer
flames can be controlled separately.
The available power levels are as follows:
Inner and outer flame on full power.
Outer flame on minimum, inner flame on full power.
9