Behaviour; Network - Konica Minolta Bizhub C203 Installation Manual

a. , Go to 'Main Menu' => 'Card / ID' => 'General Settings' => 'Cost Centre Selection'.
b. If everybody is required to use a Cost Centre (Client Code), choose 'Required' and confirm with
not be able to use budget purses if there is no server connection.
c. If you don't use Cost Centres, choose 'Never' and confirm with
d. If you only want to use it if the server is online, choose 'If online' and confirm with
e. Go to step 5.
4. Store Value on Terminal:
a. Set the account mode.
b. If you want all tags to be accepted select 'Allow all ID's' and confirm with
c. If you want to accept only tags that are registered in your PayCon select 'Allow accounts' and confirm with
d. Setting up the accounts:
· , Go to 'Main Menu' => 'Card/ID' => 'Terminal Accounts' => 'Add'.
· Type a card or account number and confirm with
· Repeat this until all accounts are set.
e. Setting the tags:
· , Go to 'Main Menu' => 'Card / ID' => 'Server Accounts' => 'Tags' => <Tag Type>.
· Select 'Disabled' and press
· , Go to 'Main Menu' => 'Card / ID' => 'Terminal Accounts' => 'Tags' => <Tag Type>.
· There are two ways to present a tag to the PayCon, you can swipe it past the reader or hold it in place on the
reader.
· Select 'Hold' or 'Swipe' and confirm with
f. Go to Step 8

Network

5. Network Settings:
a. , Go to 'Main Menu' => 'Terminal' => 'Network'
b. Set the 'host name' to an identifiable name.
c. Confirm with .
d. If DHCP is used and go to step 7.
e. If DHCP isn't used, set it to 'disabled' and confirm with
6. Fixed IP addresses:
a. Set 'IP-address' to an IP-address in your network range and confirm with
b. Set the subnet mask ('netmask') to '255.255.255.0' or to the subnet mask needed in your network and confirm with
.
c. Set the 'default gateway' to the IP-address of the default gateway in your network and confirm with
7. DB Settings:
, Go to 'Main Menu' => 'DB Connectivity' => 'Server'
a.
b. Set the IP-address of the PCounter server in 'Sever Address' and confirm with
c. , Go to 'Main Menu' => 'DB Connectivity' => 'Transaction log'
d. Select 'Enabled' and confirm with
e. , Go to 'Main Menu' => 'DB Connectivity' => 'Printjob client'
f. Select 'Enabled' and confirm with
, Go to 'Main Menu' => 'Card/ID' => 'Terminal Accounts' => 'Account Mode'.
.
.
.
.
.
and go to step 4e.
to add an account.
.
.

Behaviour

. The users will
.
.
.
Version 2.2.20
.
- 27