3. Use the rip tie to attach the power cable and connection cable to the flap, thus creating a cable relief, and clip the rip tie using the wire
cutter
4. Close and gently screw down the last flap and place the PayCon bracket on the PayCon with the screws from the bracket kit
5. Place the ferrite cores and loop the network cables through them once
Attach the PayCon bracket to the copier
The mounting instructions differ for the different type of copiers its supports. The instructions for each part will start with
the list of copiers that the instructions are meant for.
- Bizhub C203
- Bizhub C253
- Bizhub C353
Attach the PayCon to the bracket
Version 2.2.20
-
13