Simplicity 2690879 Operator's Manual page 18

Conquest series, 24hp hydro tractor, 52” 132 cm mower deck
Table of Contents

Advertisement

OPERATION
WARNING
Engines give off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause
nausea, fainting or death.
Start and run engine outdoors.
Do not start or run engine in enclosed area, even if
doors or windows are open.
1. While sitting in the operator's seat, fully depress the
brake pedal or set the parking brake.
2. Make sure that your feet are not depressing the ground
speed control pedals and that the cruise control lever is
in neutral.
3. Disengage the PTO clutch.
4. Set the throttle to FULL.
5. Close the choke.
NOTE: A warm engine may not require choking.
6. Insert the ignition key and turn it to START.
7. After the engine starts, move the engine throttle control
to half speed. Warm up the engine by running it for at
least 30 seconds.
8. Set throttle to FULL.
NOTE: In the event of an emergency the engine can be
stopped by simply turning the ignition switch to STOP. Use
this method only in emergency situations. For normal en-
gine shut down follow the procedure given in Stopping the
Tractor and Engine.
Driving the Tractor
1. Sit in the seat and adjust the seat so that you can com-
fortably reach all the controls and see the dashboard
display.
2. Engage the parking brake.
3. Make sure the PTO switch is disengaged.
4. Start the engine (see Starting the Engine).
5. Disengage the parking brake and release the brake
pedal.
18
6. Depress the forward ground speed control pedal to
travel forward. Release the pedal to stop. Note that the
further down the pedal is depressed the faster the trac-
tor will travel.
7. Stop the tractor by releasing the ground speed control
pedals, setting the parking brake, and stopping the en-
gine (see Stopping the Tractor and Engine).
Mowing
1. Set the mower cutting height to the desired level using
the mower lift lever.
2. Engage the parking brake. Make sure the PTO switch is
disengaged.
3. Start the engine (see Starting the Engine).
4. Set the throttle to FULL.
5. Engage the PTO to activate the mower blades.
6. Begin mowing.
7. When finished, shut off the PTO and raise the deck
using the mower lift lever.
8. Stop the engine (see Stopping the Tractor and
Engine).
WARNING
The engine will shut off if the reverse ground speed
pedal is depressed while the PTO is on and the
RMO has not been activated. The operator should
always turn the PTO off prior to driving across on
roads, paths or any area that maybe used by other
vehicles. Sudden loss of drive could create a
hazard.
WARNING
Mowing in reverse can be hazardous to bystanders.
Tragic accidents can occur if the operator is not
alert to the presence of children. Never activate
RMO if children are present. Children are often
attracted to the unit and the mowing activity.
www.simplicitymfg.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents