Simplicity 2690879 Operator's Manual page 19

Mowing in Reverse
If an operator chooses to mow in reverse, the RMO sys-
tem can be used. To use the Reverse Mowing Option
(RMO) turn the RMO key after the PTO is engaged. The
L.E.D. light will illuminate, and the operator can then mow
in reverse. Each time the PTO is engaged the RMO needs
to be reactivated if desired. The key should be removed to
restrict access to the RMO feature.
Pushing the Tractor by Hand
1. Disengage the PTO and turn the engine off.
2. Push the lever approximately 2.3/8" (6 cm) to release
the transmission (B, Figure 5).
3. The tractor can now be pushed by hand.
DO NOT TOW TRACTOR
Towing the unit will cause transmission dam-
age.
• Do not use another vehicle to push or pull
this unit.
• Do not actuate the transmission release
valve lever while the engine is running.
Adjusting Mower Cutting Height
The cutting height is infinitely adjustable between approxi-
mately 1.5 - 4.0" (3,8 - 10,2 cm).
The cutting height adjustment switch controls the mower
cutting height (B, Figure 6). This same switch also controls
the spout rotator motor when a snowthrower is installed.
The arrows on the switch correspond to the direction of ad-
justment (UP arrow raises cutting height, RIGHT arrow ro-
tates the spout right, etc). When the adjustment indicator
has reached the end of its travel, release the switch; hold-
ing the switch down will damage the motor.
Attaching a Trailer
The maximum horizontal drawbar force allowed is
444 Newton. The maximum vertical drawbar force is
222 Newton. This equates to a 396 lbs (180 kg) trailer on a
10 degree hill. Secure the trailer with an appropriately
sized clevis pin (A, Figure 7) and clip (B).
Stopping the Tractor and Engine
1. Return the ground speed control(s) to neutral.
2. Disengage the PTO and wait for all moving parts to stop.
3. Move the throttle control to SLOW position and turn
the ignition key (A, Figure 6) to OFF. Remove the key.
OPERATION
19