Simplicity 2690879 Operator's Manual page 15

Conquest series, 24hp hydro tractor, 52” 132 cm mower deck
Table of Contents

Advertisement

Differential Lock Pedal (Select Models)
Depressing this pedal locks the transmission differential,
locking both rear wheels into "drive".
Use this feature if the tractor is stuck because one wheel is
slipping. Engage the differential lock at slow ground
speeds only.
Steering Tilt Adjust
Use the tilt knob located on the bellows to release the pivot
mechanism and pivot the wheel to the desired position. Re-
lease the tilt knob to lock in position.
Attachment Lift Control Lever
When using the mower deck, lift the deck off the ground
while transporting to and from the job site. DO NOT cut with
the mower in the raised, transport position.
The attachment lift control lever raises and lowers attach-
ments that utilize the tractor's manual lift linkage. To lower
an attachment: pull the lever back slightly, depress the re-
lease button, and push the lever forward until it locks in the
lowered position. To raise an attachment: push the lever for-
ward slightly, depress the release button, then pull the lever
back until it locks in the raised position.
Parking Brake Function
Applying the Parking Brake - See Figure 2. To lock the
parking brake, release the ground speed pedals (A), fully
depress the brake pedal (B), pull UP on the parking brake
knob (C), and then release brake pedal.
Releasing the Parking Brake - See Figure 2. To release
the parking brake, fully depress the brake pedal (B) and
push the parking brake knob (C) DOWN.
IMPORTANT NOTE: The tractor's hydraulic attachment lift
will not work when the parking brake is engaged.
FEATURES AND CONTROLS
Dashboard Display & Functions
Display Items
Refer to Figure 3.
A. FUEL LEVEL
Indicates the amount of fuel in the fuel tank. Left is empty;
right is full.
B. HOUR METER / CLOCK / SERVICE INDICATOR
Displays the clock, hour meter, and maintenance reminder.
The hour meter measures the number of hours the key
has been in the RUN position. The hour meter will flash an
initial oil change indicator at 5 hours, and a lubrication re-
minder every 50 hours. These reminders display for ap-
proximately two hours and will automatically reset
themselves.
NOTE: The hour meter will register the passage of time
when the key is in the RUN position, even if the engine is
not running. The hour meter has a self contained power
source so the total hours are always visible.
C. SELECT BUTTON
Used to set the clock and reset the maintenance reminder.
D. SET BUTTON
Used to set the clock and reset the maintenance reminder.
E. PTO LIGHT
Indicates the PTO switch is in the ON position.
F. CRUISE CONTROL LIGHT
Indicates that the cruise control is engaged.
G. LOW OIL PRESSURE LIGHT
Indicates that the engine oil pressure is low. The light will
turn on when the tractor is first started and then go out. IF
THIS LIGHT TURNS ON WHILE THE TRACTOR IS IN
USE, TURN THE ENGINE OFF IMMEDIATELY. Contact
your authorized dealer for service.
H. LOW VOLTAGE LIGHT
Indicates that the electrical system voltage is low. The light
will turn on when the tractor is first started and then go out. IF
THIS LIGHT TURNS ON WHILE THE TRACTOR IS IN
USE, TURN THE ENGINE OFF IMMEDIATELY. Contact
your authorized dealer for service.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents