Ferris FAST-Vac Operator's Manual page 20

Installation
Assemble Collector Hood
1. Install the inlet tube (B, Figure 28) to the collector
back plate (A) and secure with the 5/16-18 x 3/4"
bolts (C) and 5/16-18 nylock flange nuts (D).
2. Install the mount posts (E) on the back plate and
loosely secure with the 3/8-16 x 1" bolts (F) and
3/8-16 nylock flange nuts (G).
NOTE: On the 3-bag collector back plate, install
the eight (8) supplied hole plugs in the remaining
mounting holes not used.
3. Install the collector onto the mount plate and
secure with the pins w/ lanyards as shown in
Figure 25. Again, this will insure that the holes
are properly aligned for easy installation and
removal.. Tighten the 3/8-16 x 1" bolts securing
the posts to the back plate.
NOTE: It is recommended that the rear suspension
be adjusted stiffer due to the added weight of
the collection system (see "Rear Suspension
Adjustment (Models Equipped with Rear
Suspension)" on page 6).
18
C
B
D
B
C
D
Figure 28. Assemble Collector Hood
A. Collector Back Plate
B. Inlet Tube
C. 5/16-18 x 3/4" Bolt
D. 5/16-18 Nylock Flange Nut
E. Collector Mount Post
F. 3/8-16 x 1" Bolt
G. 3/8-16 Nylock Flange Nut
www.ferrismowers.com | www.snapperpro.com
2 Bag Collector
A
E F
G
3 Bag Collector
A
E
F
G