Preparing The Blower Mount For Assembly - Ferris FAST-Vac Operator's Manual

Installation

Preparing the Blower Mount for Assembly

Inspecting the Blower Mount Assembly
Some blower mounts are equipped with an adjustable
deflector bracket (A, Figure 7). If your blower mount
is equipped with an adjustable deflector bracket it will
need to be adjusted prior to performing the Blower
Assembly procedure. If not, proceed with the Blower
Assembly procedure.
Adjusting the Blower Mount Assembly Adjustable
Baffle
1. Temporarily install the blower mount (A, Figure 8)
onto the mower deck (B). Refer to Figure 8 for
the position of the pins w/ lanyards in relationship
to the chute mount bracket on the mower deck.
The pins w/ lanyards fit into the same holes that
the chute mount rod was installed.
2. Loosen the two (2) 5/16" nylock flange nuts (A,
Figure 9) that secure the deflector bracket (B) to
the blower mount (C).
3. Slide the deflector bracket up against the front
baffle (D) of the mower deck (E) .
4. Tigthen the two (2) 5/16" nylock flange nuts.
5. Remove the blower mount and pins w/ lanyards
from the mower deck.
10
A
Figure 7. Inspecting the Blower Mount Assembly
A. Adjustable Deflector Bracket
B
Figure 8. Install Blower On Deck (Notice Pin
Orientation)
A. Blower Mount
B. Mower Deck
E
Figure 9. Adjusting the Deflector Bracket
A. 5/16" Nylock Flange Nuts
B. Deflector Bracket
C. Blower Mount
D. Front Baffle
E. Mower Deck
www.ferrismowers.com | www.snapperpro.com
A
C
A
B
D