Prime Mode; Setup Mode - Graco L20c Operation

Supply systems
Hide thumbs Also See for L20c:
Table of Contents

Advertisement

Remote DataTrak Operation

Prime Mode

See F
. 20.
IG
1. Press
to enter Prime Mode screen. The Prime
symbol (PS) will appear in the display and the LED
(B, F
. 16) will flash.
IG
PS
F
. 20: Prime Mode Screen
IG
2. While in Prime Mode, the job total counter (JT) is
blank and will not count. However, the maintenance
counter (MC) will continue to decrement.
3. When a new drum is installed, press and hold
while in Prime Mode to reset the drum volume
remaining (DV) to the drum fill volume (DF).
4. To exit Prime Mode, press
will disappear and the LED will stop flashing; the
screen will return to Run Mode (F
5. To enter Setup Mode, press and hold
onds.

Setup Mode

If a key is not pressed within one minute of entering
a setup screen, the system will return to Run Mode
(F
. 19).
IG
See F
. 16. Press and hold
IG
If a password has not been assigned (set to '0000'),
the system will go directly to Setup screen 1.
26
JT
MC
. The Prime symbol
. 19).
IG
for 3 sec-
for 3 seconds.
Password Screen
If a password has been assigned (not set to '0000'), the
Password screen will appear (F
word to access the Setup screens.
F
. 21: Password Screen
IG
1. To enter a password, press
2. Once in edit mode, press
3. Press
to select the correct digit and move on to
the next.
4. When password is correct, press
most digit to submit the password.
Setup Screen 1
Use Setup screen 1 to set runaway cycle rate (RS),
enable/disable runaway protection (RT), select pump
volume per cycle (PV), select flow rate units (FR), enter
drum size (DS), and enter drum fill volume (DF). See
F
. 22.
IG
1. Press
to toggle from field to field through the
screen.
If you go past a field you want to edit, toggle
through the remaining fields, exit the Setup mode,
and reenter Setup. It is impossible to back up in the
Setup screens.
2. Press
to scroll through available values for each
field.
3. Press
again to set the value and move the cur-
sor to the next data field.
. 21). Enter the pass-
IG
to enter edit mode.
to scroll through digits.
on the right-

Advertisement

Table of Contents
loading

This manual is also suitable for:

D200D200sS20D60

Table of Contents