Table of Contents
Advertisement
0 – iR1200
Sends updates to the firmware.
Firmware
Update
i – Radio
Obtains information specific to
Information
the modem.
d – Deregister
Forces the modem to deregister
From
from the iDEN
Network
r – Register with
Forces the modem to register with
Network
the iDEN
h – iR1200
Checks the modem's data
Config Data
configuration.
Unsolicited Firmware Updates
We want to emphasize that this diagnostic option should be executed only when instructed by an eLutions' Customer Care
Representative. However, there are certain sequences of events that will prompt you for a firmware update.
!
1 Modem is OFF (all cables are connected except for the power connector), the computer is ON and the
HyperTerminal session is ACTIVE.
2 Modem is then switched ON (power connector is inserted into the power slot).
3 The HyperTerminal session automatically presents the option 0 – Firmware Update prompt.
4 Once the modem has successfully registered with the network, the HyperTerminal will present you with
the Diagnostic Menu.
To safely exit out of the update firmware mode, please select "N". There will be
!
about a 1-minute delay before the system returns you to the diagnostic menu. This
is because the modem is attempting to register with the iDEN
www.telusmobility.com
®
Network.
®
network.
IMPORTANT: The following lists the sequence of events that will cause
HyperTerminal to prompt you for firmware update.
WARNING: We do not recommend that you perform this
command unless otherwise instructed by an eLutions'
Customer Care representative.
•
Serial Number
•
IMEI
•
SIM ID
•
Software Version
DEREGISTERED
REGISTERED
•
Hardware Part ID
•
Serial number
•
Boot Loader
•
Application ID
®
network.
iR1200 Modem
29
Advertisement
Table of Contents
