Table of Contents
Advertisement
In this chapter, you will learn how to install your iR1200 modem and antennas in a mobile environment.
Installation Steps
To install, you must perform the following steps:
•
Mount Modem – Mount the modem in the desired location.
•
Mount Antenna – Mount the antenna using the instructions included with your selected antenna's installation guide.
•
Mount GPS Antenna (GPS-Enabled Modem only) – Mount the antenna using the instructions included with your GPS
antenna's installation guide.
•
Route and Connect Power Cable – route the power cable from modem to the vehicle's power supply (ignition switch).
•
Route and Connect the Ignition Cable – Route the ignition cable from the modem to the ignition.
•
Route and Connect Antenna Cable – Connect the cable to the mounted modem and antenna.
•
Route and Connect Data Cable – Connect the data cable from the modem to the mobile device.
Mounting the Modem
Select Modem Location
The following describes typical locations that you should consider for mounting the modem:
•
Under seat
•
Under dashboard
www.telusmobility.com
Installation Steps
Mounting the Modem
Select Modem Location
Mount the Modem
Mounting the Antenna(s)
Approved Antennas
Select Antenna Location
Mount the Modem Antenna
Mount the GPS Antenna
Route and Connect Cables
Approved Cable
Route and Connect Power Cable
Route and Connect Ignition Cable
Route and Connect Antenna Cable(s)
Route and Connect Data Cable(s)
Other Installation Configurations
Continuous Power Configuration
Configuration for Docking Station
•
In trunk
•
In accessory compartment
MOBILE INSTALLATION
Page 11
Page 11
Page 11
Page 12
Page 12
Page 12
Page 12
Page 13
Page 13
Page 13
Page 13
Page 14
Page 15
Page 15
Page 15
Page 15
Page 15
Page 17
•
Center console
iR1200 Modem
11
Advertisement
Table of Contents
