Route And Connect Antenna Cable(S); Route And Connect Data Cable(S) - TELUS iR1200 Installation Manual

TELUS Mobility™
1 Connect the male end of the ignition cable to the 4-prong connector labeled IGNITION on the modem.
2 Connect the free end of the ignition cable to a fused +12VDC circuit controlled by the laptop/MDT
docking station (see Figures 10 and 11 on page 17). This circuit shall nominally output 12Vdc @ 5mA
when the modem is intended to be ON, and 0Vdc (open circuit) when the modem is intended to be
OFF.

Route and Connect Antenna Cable(s)

Connect the antenna cable(s) as described for the standard mobile installation on page 15.

Route and Connect Data Cable(s)

Connect the data cable(s) as described for the standard mobile installation on page 15.
18 www.telusmobility.com