External Components - Kenwood DNX9180DABS Instructions Manual

Connection/Installation
Ñ
3 way speaker system setup
NOTE
• For speaker system setup, see 3 way speaker
system setup (P.67).
• For speaker setup and crossover setup, see
Speaker/ X'over setup (P.68).
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.86) and Connecting
wires to terminals (P.85).
Subwoofer Preout
Mid Range Preout
Tweeter Preout
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
Power amplifier
(optional
accessory)
Input
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Speaker impedance: 4-8 Ω
86
Speaker
+
To mid range left
speaker
+
To mid range right
speaker
+
To tweeter left speaker
To tweeter right
+
speaker
Ñ
Connecting the system and

external components

11 10 9
1
2
3
4
5
HDMI input
1
Use HDMI cable KCA-HD100 (optional
accessory).
When you connect the cable to HDMI terminal,
remove the fixture. After connecting the cable,
put the fixture again.
2
Accessory @: DAB antenna
(DNX9180DABS only)
AV Audio output (ø3.5 mini jack)
3
FM/AM antenna input
4
When connecting to an external amplifier,
5
connect its ground wire to the car's chassis to
avoid damaging the unit.
Rear Audio Preout
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
Subwoofer Preout
(Left; White, Right; Red)
TV tuner remote output
6
14
13
12
8 7 6
Fixture
HDMI connector