Mitsubishi Q64AD User Manual page 59

5 UTILITY PACKAGE (SW0D5C-QADU-E)
[Explanation of items]
(1) Contents of screen display
Setting item
Current value
Setting value
(2) Explanation of the command buttons
Current value display
Make text file
Start monitor /
Stop monitor
Select test
Close
POINT
If the selection test operation is performed while deleting the setting value using the
Delete key (the setting value field is blank), the message "Completed" will be
displayed but write operation will not be performed.
REMARK
The following describes an example where sampling process for the selection test
operation is changed to a 10-time averaging process setting.
(1) Set averaging process in the setting value field for CH
process/Averaging process setting.
(2) Set number of times in the setting value field for CH
specifying.
(3) Click the setting value field for CH
setting to select.
(4) After entering the average number of times, press the Enter key.
At this point, nothing has been written to the A/D conversion module.
(5) Select the setting value fields that were specified in steps 1 to 4 while holding
down the Ctrl key.
(6) Click Select test to execute write operation.
Once writing has been completed, the value that was written will be displayed in
the present value field.
: The I/O signal or buffer memory names are displayed.
: The I/O signal status or current value of buffer memory are
monitored.
: Select or enter the data to be written during test operation.
The current value of the selected item is displayed.
(This is used to check text that cannot be displayed in
the current value field. However, in this utility package,
all items can be displayed in the display fields).
Creates a file consisting of the screen contents in text file
format.
Selects whether or not the current value fields are
monitored.
Performs a test of the selected item. To select more
than one item, select multiple items while holding down
the Ctrl key.
Closes the screen currently displayed and returns to
the previously displayed screen.
Average time/average number of times
5 - 16
MELSEC-Q
Sampling
Time/number of times