Mitsubishi Q64AD User Manual page 24

3 SPECIFICATIONS
Device No. Signal name
Operating
Y9
condition setting
request
User range write
YA
request
Channel change
YB
request
Maximum value/
YD
minimum value
reset request
YF Error clear request
(2) Output signals
(1) This turns ON when A/D conversion is enabled/disabled, or when averaging
processing specification, the settings for the average time or number of times (when
averaging processing is specified) is enabled.
(2) See the X9 column for ON/OFF timing.
(1) This turns ON when the value for the adjusted offset/gain settings are registered in
the A/D conversion module.
(2) See the XA column for ON/OFF timing.
See Section 4.6 for offset/gain settings.
(1) This turns ON when changing the channel for which offset/gain settings are to be
performed.
(2) See the XB column for ON/OFF timing.
See Section 4.6 for offset/gain settings.
(1) The maximum and minimum values stored in buffer memory addresses 30 to 45
(Un\G30 to Un\G45) are cleared by setting the maximum and minimum value reset
request (YD) to ON.
(1) This turns ON when a write error is cleared.
(2) See the XF column for ON/OFF timing.
Description
3 - 11
MELSEC-Q