Fault Codes - Basic; If There Is A Fault (Active); If Warning Or Last Fault Is Indicated; Basic Fault Code Chart - Hotpoint FDYF11011K Service Information

Indesit Company

FAULT CODES - Basic

If there is a fault (active):

The service technician will find the machine immobilized, with the Fault Code shown in the display and
other LEDs on the Control Panel blinking (usually On/Off, Salt and Rinse Aid).
Refer to the Fault Code chart below for guidance.

If Warning or Last Fault is indicated:

Starting the autotest, the last Fault or the current Warning will be displayed for 20 seconds.
Once this time has elapsed, the autotest sequence starts automatically.
If the autotest reaches the end, the Last Fault will be reset.
Should the Autotest procedure be interrupted for whatever reason, data in the Last Fault memory will be
saved. N.B.: The "Last Fault detected electronically" will always be displayed.

Basic Fault Code Chart

Fault
F01
ANTI-FLOODING OVERFLOW
F02
WATER FILL SOLENOID VALVE FAILURE
F03
DRAIN TIMEOUT
F04
THERMISTOR (NTC) not compliant
F05
Not applicable to this model
F06
WATER FILL TIMEOUT
F07
WATER TURBINE damaged
F08
TEMPERATURE TIMEOUT (1 hour)
F09
Software recognition error.
F10
HEATING ELEMENT CIRCUIT not compliant
F11
Not applicable to this model
F12
COMMUNICATION error between main board and display
F13
MAIN BOARD not Working
F15
VIRTUAL SENSOR - Inconsistent readings
For more detailed information refer to next page.
Service Manual UK
Possible Cause
5 of 39
English