Indesit
Company
Module Programming
The module will always be supplied without a programme when supplied as a spare part.
NOTE: This module DOES NOT have a physically replaceable Eeprom.
Programming Access Panel - situated beneath the Dishwasher Door.
Programming a Main Board
There are a number of ways the board can be programmed - some of which are not applicable to certain
markets.
Types of programming:
1. Handheld Terminal (Not UK)
2. Emit / Memwriter (UK Indesit Service Engineers)
3. Smart Reader & Smart Card (certain areas of UK market) - see following pages.
PROGRAMMING (Using EMIT)
You MUST hold the Reader in place whilst programming is taking place.
NOTE: This board does NOT have a physically replaceable EEProm.
This machine can be programmed via the Emit PC, using a USB lead (Part No. C00289046),
Hardware key (Part No. C00289048) and the Memwriter software.
USB Hardware Key and USB Cable
Part No. C00289046
A
Connector pins
Service Manual UK
Use a small flat bladed screwdriver to release the panel
Part No. C00289048
33 of 39
A = USB connector
B = not used
A
B
English