Going To An Individual Target Point - Raymarine Raychart 320 Owner's Handbook Manual

3-38

Going To an Individual Target Point

Rather than following a route, you can go directly to a selected target
point. This can be an existing waypoint (not in the current route) or the
cursor position.
➤
To navigate directly to an existing waypoint:
1. Select the waypoint from the Waypoint List as described in
or...
2. Press the GOTO WAYPOINT soft key.
3. To return to the default soft key display, move the cursor away from
➤
To navigate directly to the cursor position:
1. Use the trackpad to position the cursor as required.
2. Press the GOTO default soft key, followed by GOTO CURSOR .
Note: The temporary waypoint is not added to the Waypoint List. When
the GOTO is complete or is stopped, the temporary waypoint remains on
the chartplotter screen until either another Goto or Follow is started or it
is removed.
3. To return to the default soft key display, move the cursor away from
Section 3.4.
Using the trackpad, position the cursor over the required waypoint
until the letters WPT and the waypoint soft keys are displayed as
shown in Figure 3-27
Navigation to the selected waypoint begins. The soft key STOP GOTO
is displayed.
the waypoint or press CLEAR .
If navigation is currently in progress you are warned ALREADY FOL-
LOWING ROUTE. CANCEL ROUTE AND GOTO CURSOR?
i. To cancel the GOTO CURSOR operation, press NO .
ii. To continue with the GOTO CURSOR operation (and stop the cur-
rent GOTO ROUTE ), press YES .
A temporary waypoint is placed as the target and navigation starts
towards it. The waypoint is shown as a square with a circle and dot at
its centre and is connected to the vessel's starting position with a
dashed line.
The STOP GOTO soft key is displayed.
the waypoint or press CLEAR .
Raychart 320 Chartplotter