Table of Contents
Advertisement
Chapter 3: Operation
Nearest
➤
To obtain the information for the nearest port facility:
1. Move the cursor to the required position - this can be anywhere on the
2. Press ENTER to display the object information pop-up.
3. Press the NEAREST soft key. The port facility symbols are displayed.
4. Use the trackpad to highlight the required facility, then press ENTER .
5. To find details for a facility, highlight a port name then press ENTER .
6. Press CLEAR to return to the port list.
7. Press CLEAR again to return to the facility symbols.
8. Press CLEAR once more to return to the default display.
3.3 Changing the Display Mode
The DISPLAY key is used to select the desired screen mode. The
following modes can be selected:
•
•
•
•
•
•
•
The modes that contain more than one page of data provide additional
soft keys which cycle through the pages. The highlighted soft key
indicates the screen mode currently displayed.
Note: Press the DISPLAY key for at least two seconds in any display
mode to return to the Chart display.
Data Display Pages
In all graphical display pages, the steering instruction is STEER
STARBOARD if the XTE is 0.01nm or more to port, STEER PORT if the XTE
is 0.01nm or more to starboard or ON COURSE if XTE is less than 0.01 on
either side.
If no Goto or follow is in progress, the steering instruction is NOT
FOLLOWING and no steering arrows are shown.
chart and may be over an object.
A list of the port(s) nearest to that facility is displayed, including dis-
tance and bearing to the port(s).
Default Chart display
GPS Data (four pages) / Waypoint Data (three pages)
Boat Data (three pages) / Environment Data (two pages)
Bearing & Distance Indicator (BDI) / Course Deviation Indicator
(CDI)
Data Boxes
Data Log
Return to default Chart display
3-7
Hide quick links:
Advertisement
Table of Contents
