System Set Up Parameters - Raymarine Raychart 320 Owner's Handbook Manual

4-2
•
•
•
4. Press the soft key corresponding to the desired setting or, for scroll
5. When all the required values have been set, press ENTER to imple-
6. Press CLEAR to clear the soft keys and return to the default display.
You can return all the settings to their original factory settings, if required,
by performing a reset as described in Chapter 6.

4.3 System Set Up Parameters

The System menus and their options are listed in Table 4-1. It also shows
the factory default setting and provides a space to make a note of the new
default setting. Each parameter is described in the following subsections.
Table 4-1: System Set Up Parameters
Menu
BEARING
MODE
CURSOR REF-
ERENCE
CURSOR
READOUT
DAY/NIGHT
HELP
SOFT KEYS
KEY BEEP
MOB DATA
As each line is highlighted, the soft keys are updated to show the set-
tings available.
For parameters that have a numeric value, or more than four possible
settings, a scroll list is displayed above two of the soft keys.
Some parameters are controlled by an adjustable slider that is dis-
played above two of the soft keys.
For some parameters, a soft key provides access to a sub-menu of fur-
ther options.
lists, use the soft keys to scroll forwards or backwards through the list
until the required setting is highlighted. This setting is retained when
you move the selection bar on to the next parameter in the menu list.
ment the changes and return to the set up soft keys.
Options
MAGNETIC or TRUE
MAG/TRUE or RELATIVE
OFF
LAT/LONG
RNG/BRG
BOTH
DAY or NIGHT
OFF or ON
OFF or ON
OFF or ON
DR or POSITION
Raychart 320 Chartplotter
Factory New
Default Default
TRUE
RELATIVE
RNG/BRG
DAY
ON
ON
ON
DR