Nortel SR1001 Installation Manual page 52

40
CHAPTER 4
Configuration
SR1001 Installation Guide
Version 8.3.5
16 Make sure to type wind. Then set the password also to wind. Press the Enter key.
The following text is output to the terminal:
ftp password [pw] [blank = use rsh] : wind
17 Set the flags. Type 0x8a. Press the Enter key.
The following text is output to the terminal:
flags [f] : Ox8a
Set the target name. Press the Enter key.
The following text is output to the terminal:
target name [tn] :T1000
The name that you use to configure the Nortel router will become the Secure Router
prompt.
Ensure that the startup script parameter is blank. The "other" parameter may be
blank or left as "lnPci."
After entering all the parameters described above, the Nortel boot prompt, "[Nortel
Boot]" is displayed.
18 Verify that the settings are correct. Press the Enter key to display the following text:
[Nortel Boot]: P
boot device
unit number
processor number
host name
file name
inet on ethernet [e]
host inet [h]
gateway inet [g]
user [u]
ftp password [pw]
flags [f]
target name [tn]
ether [e]
19 Type @ and press the Enter key to boot from the network.
20 Download the new images. Refer to Upgrading Software on page 37.
:
lnPci
: 0
: 0
: host
:
tftpdir/8.0/T1000.Z
:
10.1.0.1:fff0000
:
10.11.12.13
: 111.2.3.254
: wind
: ****0
: 0x8a
: T1000
: lnPci
Booting From a Network TFTP Server