Servicing - Rangemaster 90 INDUCTION U109941 - 02 Installation And User Manual

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.

8. Servicing

Fig.8-1
ArtNo.270-0019 - Proplus tags 1
Fig.8-2
ArtNo.270-0019 - Proplus tags 2
Disconnect the cooker from the electricity supply

before servicing, particularly before removing any
of the following: control panel, side panels, ceramic
hob, or any of the electrical components or cover
boxes.
Before reconnection, check that the appliance is

electrically safe.
1. To Remove the Control Panel
Pull off all the control knobs.
Open the grill and right-hand oven door and remove the four
fixing screws underneath the control panel.
The control panel should drop down slightly. It is held at the
top by two holes in the top edge (Fig.8-1), one at each end,
that locate on tags on the inner panel.
Lift the control panel clear of the tags and pull the control
panel forward (Fig.8-2).
Disconnect the wiring from the rear.
Reassemble in reverse order. When replacing leads, refer to
the wiring diagram in this manual. Check the operation of the
timer.
2. To Remove a Side Panel
Disconnect from electricity supply.
Remove the control panel (see 1). Pull the cooker forward.
Remove the four retaining screws for each panel (one at the
front base, one on the top, and two at the rear).
Reassemble in reverse order.
3. To Lift up the Ceramic Hob
Disconnect from electricity supply.
Pull the cooker forward. Unscrew the two screws that are
located at the rear, on either side of the cooker. Remove the
control panel and side panels (see 1 and 2). Unscrew the two
screws located at the front on either side of the cooker. Lift the
hob.
CAUTION: The ceramic hob material is much more sensitive
to scratches on the underside than the top.
Take care not to touch or scratch the underside of the ceramic
as this will weaken the material and cause the top to shatter.
4. To Replace a Hob Element
Disconnect from electricity supply.
Lift up the ceramic hob (see 3). The Induction Heating
Elements (IHE) are now accessible. Note the wire connection
positions and element orientation for re-assembly. Disconnect
the wires, and remove the element unit and springs. Re-
assemble in the reverse order.
Note: The IHE will require commissioning when the hob has
been refitted.
22
ArtNo.081-0003 - Service - 90 induction