Rangemaster 90 Induction Cooker U109976 - 02 Installation And User Manual page 26

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Fig.8-3
�
ArtNo.320-0001 Door hinges
Fig.8-5
ArtNo.320-0006 Oven door hinge adjustment 1
Effect of hinge adjustment - exagerrated for clarity
Fig.8-6
Centreline of hinge pin
ArtNo.320-0007 Oven door hinge adjustment 2
Oven door omitted for clarity
Fig.8-7
ArtNo.320-0002a Proplus oven door side screws
Fig.8-8
�
ArtNo.320-0003 Oven door latch
Fig.8-4
�
ArtNo.320-0001 Door hinges
24
9. To Replace an Oven Door
Open the oven door. Support the door and remove the two
screws securing the upper hinge and gasket to the cooker
front (Fig.8-3). Remove the door from the lower hinge by
lifting slightly and moving outwards (Fig.8-4).
The door is heavy, so take care.

Reassemble in reverse order.
10. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to alter
the angle of the door (Fig.8-5). Loosen the bottom hinge
fixing screws and use the notch and a flat bladed screwdriver
to move the position of the hinge to set the hinge position
(Fig.8-6).
Retighten the hinge screws.
11. To Replace the Main Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel fixing
screws from the door sides – two each side (Fig.8-7).
Carefully lift off the outer door panel.
Remove the door handle from the panel by unscrewing the
two retaining nuts. Fit the door handle to the new panel.
Fit the panel to the door. Reassemble in reverse order.
12. To Replace the Tall Oven Door Outer Panel
Remove the oven door (see 9). Lay the door face down on a
suitable surface and remove the two screws from the bottom
edge of the door and the two screws from the inside face of
the door.
Remove the outer door panel. Remove the handle by
unscrewing the two screws.
Unscrew the two cross-headed screws holding the door
handle fixing bracket to the door panel. Fit the door handle
bracket and door handle to the new panel.
Fit the panel to the door and reassemble in the reverse order.
13. To Change the Main Oven Door Latch
Remove the outer door panel (see 11). Remove screws 'B' that
hold the latch assembly to the inner door panel (Fig.8-8). Fit
the new catch and reassemble in reverse order.
Verify the door operation.
14. To Adjust the Main Oven Door Catch Keep
Open the oven door, and slacken off the locknut at the base of
the keep (Fig.8-9).
Screw in or out as required until the required fit is obtained.
Retighten the locking nut.
15. To Replace the Tall oven Magnetic Latch
Remove the control panel (see 1). Remove the plinth
(3 screws) and the central vertical cover (5 screws). Prise the
retaining clip off the magnet unit.
Fit the new unit and retaining clip, and reassemble in reverse
order. Check that the door operates correctly.