Table of Contents
Advertisement
15-1994.fm Page 48 Tuesday, February 29, 2000 2:04 PM
Problem
You can turn your
Some audio components might
audio component
need both a Tuner/Receiver code
on and off and
and an Amplifier code to control all
control its vol-
features.
ume, but you can-
not change preset
channels.
Your satellite
The codes listed in this manual are
receiver does not
set up to operate your satellite
respond to the
receiver on the 1st or 2nd addresses
codes listed in the
only.
manual.
Make sure the satellite receiver you
are setting up can be operated with
an infrared remote.
The 6-in-One
Some Bang & Olufsen and other
does not operate
manufacturers' equipment operate
Bang & Olufsen
at frequencies higher than 100 kHz.
audio equipment.
The 6-in-One will not operate such
devices.
SEARCHING FOR A CODE
If you have tried all the codes from the list and your
device still will not respond to the 6-in-One (or if your
brand is not listed), try searching for your code.
Follow these steps, using the appropriate device key
in Step 1, for each device you need to find. For ex-
ample, to find the code for your TV:
1. Turn on your TV, then press
2. Hold down
until the red light blinks twice, then
P
press
. The red light blinks twice again.
9 9 1
3. Aim the remote control at the TV.
4. Repeatedly press
turns off.
Need help? Call 1-888-284-8735
48
Solution
.
TV
then
until the TV
PWR
TV
Hide quick links:
Advertisement
Table of Contents
