Table of Contents
Advertisement
•
Broken or defective product.
•
Products that operate over 100 kHz.
•
Infrared keyboards a nd infrared pointing devices (such as
mouse substitutes).
•
All products for sale and/or use outside the continental United
States, Hawaii, Alaska, or Canada.
TROUBLESHOOTING
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
No display at all times.
Replace batteries with four new AAA alkaline batteries.
No display when programming.
Display has turned off due to inactivity.Start programming
again and do not pause while performing instructions.
Remote Finder does not work.
Replace battery with new 9-volt alkaline battery; also
verify Finder Receiver is enabled (see page 39).
During programming, the bottom IR segment displays a
long flash.
An invalid entry has occurred. Check the keys to be
pressed and start program again.
How do I stop programming?
Press
once to return to the program keys screen.
Press it once more to exit completely.
The unit does not control home entertainment devices
or commands are not working properly.
Try all listed codes for the device brands being set up.
Make sure they can be operated with an infrared
remote control.
Tried Searching For Your Code method and still could
not find a working code.
Perform Restoring Factory Default Settings on page 40.
Then repeat Searching For Your Code on page 17.
Cannot program a macro onto M1~ M4, PWR, or COM
MUTE keys.
Make sure the total number of key presses being
programmed is less than 15.
Upgrade Exclusions/Troubleshooting 43
O
'
M
WNER
S
continued on next page...
ANUAL
Hide quick links:
Advertisement
Table of Contents
