Command Sequences; Setting A Sequence; Erasing A Sequence - Radio Shack 15-1925 Owner's Manual

15-1925.fm Page 15 Monday, July 19, 1999 12:59 PM

COMMAND SEQUENCES

You can set up your 6 in 1 IR/RF Remote Control
to issue a set of up to 15 commands at the press
of a key. Any sequence of commands you regu-
larly perform can be reduced to a single key
press.

Setting a Sequence

Here is an example of how to set up a sequence
of commands that turns on your cable box and
your TV and puts the TV on Channel 3, and how
this sequence works when you press
Note: The 6 in 1 must be pointed at the device.
1. Hold down
SET UP
twice, then release it.
2. Press – – . The red light blinks twice
9 9 5
again. Then press
3. Press –
CBL PWR
.
CBL
Note: If your device requires the use of an
ENTER key to select a channel, you must
also use in your sequence.
ENTER
4. To end the sequence, hold down
until the red light blinks twice.
Whenever you press the selected sequence key,
your 6 in 1 IR/RF Remote Control issues the se-
quence of commands you entered.

Erasing a Sequence

1. Hold down
SET UP
twice.
2. Press – – . The red light blinks twice.
9 9 5
Press the sequence key you want to erase.
Need help? Call 1-800-950-7044
VIDEO SEQ
until the red light blinks
VIDEO SEQ .
– – – – –
TV PWR TV 0
SET UP
until the red light blinks
.
–
3
15