Ryobi AP13 Operating Manual page 3

Stock Rollers
Power Switch
Overload Switch
Table Extention
SAFETY INSTRUCTIONS FOR AP13
1) Always wear eye protection when operating the machine.
2) Check to make sure all holding screws are tight before
starting machine.
3) Always stop the motor and disconnect from power
source before making any adjustments.
4) Be sure all guards are in place before operation.
5) Read owner's manual thoroughly and familiarize yourself
with the machine before operation.
6) Do not force work through the machine. Allow the planer
to apply the proper feed rate.
7) Check feed rollers occasionally to be sure sawdust and
chips are not lodged between any components. If rollers
are not seated firmly, the feed rolls will not hold stock
firmly against the bed, allowing kickback.
8) Only plane wood boards.
9) Use sound lumber, with no loose knots and as few tight
knots as possible.
10) Never stand directly in line with either the infeed or
outfeed sides. Always stand off to one side of the
machine.
11) Make sure the workpiece is free of from nails, screws
stones and other foreign objects which could damage
the blades.
12) Make sure the blades are attached correctly as described
in the instructions.
13) Use caution when handling the blades and cutterhead
assembly. The blades are sharp and can easily cut your
hand.
14) Allow the cutterhead to reach full speed before using.
TABLE OF LOOSE PARTS
1) "C" Circlip ......................................................4 pieces
2) Blade Setting Guide ........................................2 pieces
3) Blade Setting Guage Shaft .............................1 piece
4) Base Lock Screw ......................8mm x 50(L) 4 pieces
5) Elevation Knob Lock Screw ......6mm x 15(L) 1 piece
6) Cutterhead Raising Hand Crank .....................1 piece
7) Allen Wrenches ............................................ 4 & 5mm
8) Open End Wrench ..........................8 x 10..... 1 piece
MOVING THE PLANER
The planer can be carried using the handles on either side of
the frame. Make sure the table extensions are closed before
moving the planer.
Page 3
Hand Crank
Depth Scale
• Properly assembled
blade setting guage.