Table of Contents
Advertisement
2. Press
to select
CW On
/
CWDX Off
Off
, and then press the
the
soft key on the base). You will
OK
hear a confirmation tone (default is CW
on/CWDX off).
Setting the Area Code
If you enter a 3-digit area code number in
the "Area Code" option, your local area
code does not appear in the Caller ID
message. For calls received from outside
your local area code, you will see a full 10-
digit number. Ô
1. Press
MENU/DEL
on the base). Select the Global Setup
menu, and then the Area Code
submenu.
2. Press the number keypad (
a 3-digit area code.
3. Press
SELECT/
on the base). You will hear a
confirmation tone.
Setting the Dial Mode
Sets the dial mode to tone or pulse. Most
phone systems use tone dialing; the default
setting is tone dialing. Set the dialing mode
to match the dialing system used by your
local phone service.
• If you are not sure of your dialing
system, set the unit to tone dialing.
Make a trial call. If the call connects,
leave the setting as is; otherwise set
the unit to pulse dialing.
• If your phone system requires pulse
dialing and you need to send DTMF
tones in certain situations during a call,
you may switch over to tone dialing
(refer to "Tone Dialing Switch-over" on
page 34).
CW On
/
CWDX On
, or
CW Off
/
CWDX
SELECT/
(or the
soft key
MENU
-
) to enter
0
9
(or the
soft key
OK
,
(or
Ô
NOTES
• If the area code has
already been stored in
memory, the stored area
code will be displayed.
To change it, use
MENU/DEL (or the
DELETE soft key or
DELETE on the base)
and number keys to
enter the new area code.
• If your calling area
requires 10-digit dialing,
do not program this
option.
Ô
25
Advertisement
Table of Contents
