Using Tone Services On A Pulse Line; Memory Dialing - Radio Shack Desktop Phone Owner's Manual

answer another call on the same line by
pressing , press
FLASH FLASH
nate between the two calls.
Note: If you do not have Call Waiting, press-
ing FLASH might disconnect current call.
USING TONE SERVICES ON
A PULSE LINE
Some special services, such as bank by
phone, require tone signals. If you have
pulse service, you can still use these special
tone services by following these steps.
1. Set on the back to
TONE/PULSE
then call the special service.
2. When the service answers, press
3. Any additional numbers you dial are
sent as tone signals.
4. Follow the normal procedures for the
special service you are using.
5. When you complete the call, place the
handset on the base to disconnect the
call. The phone automatically resets to
the pulse mode.

MEMORY DIALING

There are two direct memories (
and ten indirect memory locations (
storing frequently used phone numbers.
The phone does not need batteries for back-
up memory. If the telephone line is discon-
nected, the phone retains numbers in
memory for up to 2 minutes.
Storing Numbers Into Direct
Memories
Follow these steps to store numbers into the
two direct memory locations:
1. Pick up the handset.
6
2. Press
again to alter- indicator flashes.
3. Press the direct memory location key
(
M1
4. Dial the number you want to store in
memory (up to 21 digits).
5. Press
indicator turns off. Return the handset to
the cradle.
Storing a Phone Number Into an
Indirect Memory
,
PULSE
1. Pick up the handset.
2. Press
* .
MUTE indicator flashes.
3. Press
memory location (
4. Dial the number you want to store in
memory (up to 21 digits).
5. Press
MUTE indicator turns off. Return the
handset to the cradle.
Dialing a Memory Number
1. Pick up the handset.
and )
M1 M2
– ) for
0 9
2. To dial a number from a direct memory,
press
To dial a number from an indirect mem-
ory, press
Using The Memory Card
To keep a record of numbers you have
stored in the phone's direct and indirect
memories, lift off the clear plastic cover over
the memory card, then write the person's or
company's name next to that number on the
memory card. There is also a quick refer-
Operation
. The STORE/MUTE
STORE/MUTE
or ).
M2
. The STORE/MUTE
STORE/MUTE
so the STORE/
STORE/MUTE
MEMORY, then enter the desired
– ).
0 9
so the STORE/
STORE/MUTE
or .
M1 M2
then
MEMORY 0–9.