Radio Shack 43-3909 Owner's Manual

www.radioshack.com
OWNER'S MANUAL —
Please read before using this equipment.
RINGER ON/OFF — Slide to
the desired setting to enable
or disable the ringer when
you receive a call.
Liquid Crystal Display —
Shows the caller's phone
number, the time they called,
and the number you dial.
CALL BACK — Press to
automatically dial the
selected caller ID record.
DELETE — Press to
delete the selected caller
ID record.
Ô
BATTERY NOTES
• Dispose of old batteries promptly and
properly.
• Do not burn or bury batteries.
• Use only fresh batteries of the required size
and recommended type.
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
• If you do not plan to use the phone for two
weeks or longer, remove the batteries.
Batteries can leak chemicals that can
destroy electronic parts.
• You must install the batteries before
connecting the telephone to the wall jack. If
no batteries are installed, the telephone and
Caller ID will not work.
• If the batteries are not replaced with two
minutes, the Caller ID and telephone
memory information may be lost.
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon
for pertinent information.
o
!
— Warning — Important
SM
d REVIEW e — Press
d or e to scroll through the
stored caller ID records.
Modular jacks
for coiled cord
PREPARATION
Ô
I
NSTALLING
Your phone requires three AA batteries (not
supplied) for power. Ô
1. Use a flat-blade screwdriver to lift and
remove the battery compartment door.
2. Insert three AA batteries into the
compartment as indicated by the
polarity symbols (+ and –) marked
inside.
3. Snap the battery compartment door
back into place. When ) appears on
the display or the display dims, replace
the batteries.
! !
IMPORTANT
Ô
— Note
MUTE — Hold
VOLUME NORM/HI
down to talk
— Slide VOLUME to
without the caller
NORM or HI to
hearing your
adjust the handset
conversation.
volume to a
comfortable listening
level.
FLASH — If you
have Call Waiting,
TONE/PULSE — Slide
press FLASH to
to the desired setting to
answer an incoming
select tone or pulse
call without
dialing.
disconnecting the
current call. Press
again to return to the
first call.
REDIAL/PAUSE —
Press to dial the last
phone number you
entered.
B
ATTERIES
Ó
— Caution — Hint
Trim Phone
with Caller ID
S L
ELECTING A OCATION
Select a location for your telephone that is:
• Near a telephone jack
• Not in the way of normal activities
M P
OUNTING THE HONE
You can mount your telephone on a wall
plate, on a wall, or place it on a shelf, desk,
or table.
On a Wall Plate
1. Plug one end
of the supplied
short modular
cord into the
modular jack
on the back of
the phone.
2. Route the cord
through the
groove on the
bottom of the base. Secure the cord
with the tabs.
3. Plug the other end of the cord into a
wall plate with a modular phone jack.
On a Wall
1. Drill two holes 3 1 / inches (82.5 mm)
4
apart, one below the other.
2. Thread two screws (not supplied) into
each hole, letting the heads extend
about 3 / inch from the wall. Be sure to
16
©
2003 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by
RadioShack Corporation.
43-3909