Specifications; Pressures; Temperatures; Thermostatic Shut-Down - Mira Select Flex Installation And User Manual

Thermostatic mixer
Hide thumbs Also See for Select Flex:
Table of Contents

Advertisement

SPeciFicationS

For type 2 and type 3 Valves, the supply
conditions specified in section: 'Type 2 and Type
3 Valves - Application' take precedence over the
operating parameters which follow.

Pressures

Max Static Pressure:
Max Maintained Pressure:
Min Maintained Pressure (Gravity System):
0.1 Bar (0.1 bar = 1 Metre head from cold tank
base to showerhead outlet).
Note! For gravity fed or other low pressure
systems (0.5 bar or below) do not fit the outlet
flow regulator (where applicable).
For optimum performance supplies should be
nominally equal.

Temperatures

Factory Pre-set (Blend) Shower:
optimum thermostatic control range:
to 43°C (achieved with supplies of 15°c cold,
65°C hot and nominally equal pressures).
recommended hot Supply:
Note! the mixing valve can operate at
higher temperatures for short periods without
damage, however this could detrimentally
affect thermostatic performance. For safety
and performance reasons it is recommended
that the maximum hot water temperature is
limited to 65°c.
cold Water range: up to
Minimum recommended differential between
hot Supply and outlet temperature: 12°C.

Thermostatic Shut-down

For safety and comfort the thermostat will
shut off the mixing valve within 2 Seconds if
either supply fails (achieved only if the blend
temperature has a minimum differential of
12°C from either supply temperature).

Connections

inlets: 15 mm compression.
Outlet: ½" BSP Flat Face (Exposed models),
15 mm Compression (Built-in models)
Standard connections are:
right, outlet - bottom (Exposed models),
top (Built-in models).
10 Bar.
5 Bar.
41°C.
35°C
60°C to 65°C
25°C.
hot - left, cold -

Flow Rates

typical Flow rates on low Pressure Systems,
Mira Select Flex with Mira Select Flex Shower
Fittings:
25
20
15
10
5
0
0
0.2
typical Flow rates on high Pressure Systems
(with 12 Litre/Min flow regulator fitted in shower
control outlet), Mira Select Flex with Mira Select
Flex Shower Fittings:
14
12
10
8
6
4
0.5 1
Supply Pressure (bar)
5
0.4
0.6
Supply Pressure (bar)
1.5 2 2.5
3 3.5 4
0.8
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents