Control Assembly - Mira Select Flex Installation And User Manual

Control Assembly

1. Unscrew the grubscrew and pull off the
temperature control knob, bearing and flow
control lever.
2. carefully unclip the concealing plate from the
backplate.
Note! Use a screwdriver in the cutout to assist
separation.
Backplate
cutout
3. attach the backplate using the two shroud
screws removed earlier. tighten the screws
until the foam seal is compressed against the
finished wall. Do not overtighten.
4. With the cutout at the bottom, locate the
concealing plate over the mixer, engage the
crosses in the concealing plate with the square
recesses in the backplate, and push firmly until
the concealing plate clicks into position.
concealing Plate
Flow control
lever
Bearing
temperature
control Knob
5. Locate the flow control lever over the control
assembly and push firmly into place.
6. Fit the bearing onto the flow lever.
Note! align the bearing with the cutouts on the
control assembly.
7. Fit the shower fittings, refer to your shower
fittings installation and user guide.
Note! For high pressure systems (above
0.5 bar) make sure that the flow regulator
(supplied) is fitted under the hose washer
(refer to illustration).
Important! The fitting of this flow regulator will
invalidate any tMV2 or tMV3 compliance due
to the minimum flow rate requirements. Do
not fit the flow regulator in TMV2 and TMV3
applications.
8. turn on the hot and cold water supplies and
check for leaks.
9. Before using the shower, refer to section:
'Commissioning'.
19
Flow control
lever
Bearing
hose Washer
Flow regulator